Laserfiche WebLink
<br />Furniture II <br /> <br />ITm~ C-l: UPHOLSTERED LOUNGE CHAI R: Furnish (six - in - all) <br />lounge chairs equal to ILl' #240 series. <br /> <br />END PANEL FRAMEWORK shall be constructed of 2" x 2" quarter <br />round solid stock posts double dowelled and glued to a 2" <br />. x 1"" lower stretcher and arm. The arm is made of 21,," xl"" <br />approx. solid oak shaped and bevelled to pattern. This <br />framework is reinforced with corner bracing and cleats. <br />Plywood panels are located on both faces and secured to the <br />cleats. The arms of the end frames arc exposed solid oak. <br />The balance of the end frames are wrapped with a layer of <br />!~" thick dacron then upholstered. <br /> <br />fRONT FRNlE RAILS shall be constructed of 1-1/8" thick x <br />Yj" wide solid stock. The front rail shall l,e secured to <br />end panel front posts by means of do~)le dowels and glue, <br />then reinforced with corner bracing." <br /> <br />BACK PANEL shall consist of top and bottom rail, 1-1/8" thick <br />x 3"" solid stock. These rails shall be secured to the panel <br />end back posts by means of double dowels and glue. The back <br />panel framework is fitted with plywood which is wrbpped with <br />1;;" dacron then upholstered. <br /> <br />SEAT AND BACK FRAMES shall be constructed of 7/8" x 4" solid <br />stock. The back frame shall be secured to scat frame by means <br />of glue and double dowels. Each corner of this frame shall <br />be reinforced by a !;;" thick triangular ply\wod gusset secured <br />with st&:le~ and g,ue. The seat frame shall be secured to <br />a wood cleat which is attached to the bottom back rail. Two <br />1- 3/4" no flat-head wood screws shall pass through the <br />cleat and into the underside of the seat frame. The hack <br />frame shall be secured to the top back rail. <br /> <br />BACK CUSHION shall be constructed of two layers of polyfoam <br />glued to the back frame. The frame shall be crisscrossed <br />with sagless webbing. The back of the frame shall be covered <br />by chipboard and a !;;" thick layer of polyfoam and upholstered. <br /> <br />SEAT CUSHIONS shall be constructed of polyfoam 4" thick and a <br />1/32" soft polyfoam \Hap glued to the seat frame. The seat <br />frame shall have a super loop wire springs with metal separators. <br />Helical springs attached to side rails. This assembly is <br />covered with upholstery. Trim shall consist of 1-1/8" diameter, <br />rubber cushioned plated steel glide on all legs. <br /> <br />DH.1ENSIONS of lounge chair shall be: 30'2" \;ide, 28" deep, <br />31"" high, arm height 24", and scat height Ill". <br /> <br />UPHOLSTERY FABRIC. shall be Valley Forge Jaq-lon Specifier II, <br />Mul~i~_ave 30~O, 100% nylon, #3329. <br /> <br />5 <br />