Laserfiche WebLink
7. Parex Incorporated. <br />8. Pleko Products, Inc. <br />9. Senergy Div.; of Harris Specialty Chemicals, Inc. <br /> 10. Sro Corp.; Sro Finish Systems Div. <br /> 11. Stuc-O-Flex International, Inc. <br /> 12. TEC Inc.; an H.B. Fuller Co. <br /> 13. United States Gypsum Co. <br /> <br />Compatibility: Substrates, adhesive, board insulation, reinforcing meshes, base- and finish-coat materi- <br />als, sealants, and accessories that are compatible with one another and approved for use by system <br />manufacturer. <br /> <br />C. Colors, Textures, and Patterns of Finish Coat: Engineer's selections from system manufacturer's full <br /> range of colors, textures, and patterns for type of finish coat indicated. <br /> <br />D. Primer-Sealer: System manufacturer's standard substrate conditioner designed to seal substrates from <br /> moisture penetration and to improve the bond between substrate of type indicated and adhesive used for <br /> application of insulation. <br /> <br />E. Adhesive for Application of Insulation: System manufacturer's standard formulation complying with <br /> the following requirements: <br /> <br /> l. Job-mixed formulation of portland cement complying with ASTM C 150, Type I, and polymer- <br /> based adhesive specified for base coat. <br /> 2. Factory-blended dry formulation of portland cement, dry polymer admixture, and fillers specified <br /> for base coat. <br /> 3. Factory-mixed formulation designed for adhesive attachment of insulation to substrates of type <br /> indicated, as recommended by system manufacturer. <br /> 4.Any formulation indicated above. <br /> <br />F. Molded-Polystyrene Board Insulation: Comply with system manufacturer's requirements, ASTM C 578 <br /> for Type I, and "EIMA Guideline Specification for Expanded Polystyrene (EPS) Insulation Board" for <br /> more stringent requirements; size boards not more than 24 by 48 inches and in thickness indicated but <br /> not more than 4 inches or less than that allowed by ASTM PS 49. <br /> <br />Reinforcing Mesh: Balanced, alkali-resistant, open-weave glass-fiber mesh treated for compatibility <br />with other system materials, made from continuous multiend strands with retained mesh tensile strength <br />of not less than 120 lbf/in, per EIMA 105.01, complying with ASTM D 578 and the following require- <br />ments for minimum weight: <br /> <br />1. Standard Reinforcing Mesh: Not less than 4.0 oz./sq, yd. <br />2. Impact-Resistant Reinforcing Mesh: Not less than 20 oz./sq, yd <br />3. Strip Reinforcing Mesh: Not less than 3.75 oz./sq, yd. <br />4. Detail Reinforcing Mesh: Not less than 4 oz./sq, yd. <br />5. Comer Reinforcing Mesh: Not less than 7.2 oz./sq, yd. <br /> <br />Base-Coat Materials: System manufacturer's standard mixture complying with the following require- <br />ments: <br /> <br />1. Factory-mixed formulation of polymer-emulsion adhesive and inert fillers that is ready to use <br /> without adding other materials. <br />2. Factory-blended dry formulation of portland cement, dry polymer admixture, and inert fillers to <br /> which only water is added at Project site. <br /> <br />EXTERIOR iNSULATION AND FINISH SYSTEMS - CLASS PB M:/Snapier/Spec 07241 - 2 <br /> <br /> <br />