My WebLink
|
Help
|
About
|
Sign Out
Home
Browse
Search
2014-008 Amending Chapter 25, Plumbing and Gas, of the Code of Ordinances of the City of Paris, adding Article IV, Irrigation Standards
City-of-Paris
>
City Clerk
>
Ordinances
>
2011-2020
>
2014
>
2014-008 Amending Chapter 25, Plumbing and Gas, of the Code of Ordinances of the City of Paris, adding Article IV, Irrigation Standards
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
8/17/2017 10:32:15 AM
Creation date
4/30/2014 4:52:08 PM
Metadata
Fields
Template:
CITY CLERK
CITY CLERK - Date
4/14/2014
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
18
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
View images
View plain text
(4) a legend; <br />(5) the zone flow measurement for each zone; <br />(6) location and type of each: <br />(A) controller; and <br />(B) sensor (for example, but not limited to, rain, moisture, wind, flow, or freeze); <br />(7) location, type, and size of each: <br />(A) water source, such as, but not limited to a water meter and point(s) of connection; <br />(B) backflow prevention device; <br />(C) water emission device, including, but not limited to, spray heads, rotary sprinkler <br />heads, quick- couplers, bubblers, drip, or micro - sprays; <br />(D) valve, including but not limited to, zone valves, master valves, and isolation valves; <br />(E) pressure regulation component; and <br />(F) main line and lateral piping. <br />(8) the scale used; and <br />(9) the design pressure. <br />See. 25 -48. Design and Installation: Minimum Requirements. <br />(a) No irrigation design or installation shall require the use of any component, including the <br />water meter, in a way which exceeds the manufacturer's published performance limitations for <br />the component. <br />(b) Spacing. <br />(1) The maximum spacing between emission devices must not exceed the manufacturer's <br />published radius or spacing of the device(s). The radius or spacing is determined by referring <br />to the manufacturer's published specifications for a specific emission device at a specific <br />operating pressure. <br />(2) New irrigation systems shall not utilize above - ground spray emission devices in <br />landscapes that are less than 48 inches not including the impervious surfaces in either length <br />or width and which contain impervious pedestrian or vehicular traffic surfaces along two or <br />more perimeters. If pop -up sprays or rotary sprinkler heads are used in a new irrigation <br />system, the sprinkler heads must direct flow away from any adjacent surface and shall not be <br />installed closer than four inches from a hardscape, such as, but not limited to, a building <br />foundation, fence, concrete, asphalt, pavers, or stones set with mortar. <br />(3) Narrow paved walkways, jogging paths, golf cart paths or other small areas located in <br />cemeteries, parks, golf courses or other public areas may be exempted from this requirement <br />if the runoff drains into a landscaped area. <br />(c) Water pressure. Emission devices must be installed to operate at the minimum and not above <br />the maximum sprinkler head pressure as published by the manufacturer for the nozzle and head <br />12 <br />
The URL can be used to link to this page
Your browser does not support the video tag.