11 - Contract with Bernal for 645 Johnso Woods Channel Bank Stablization Project

Home Browse Search

SUPPLEMENTAL GENERAL CONDITIONS Yrs i The terms used in these Supplementary Conditions that are defined in the Standard General Conditions of the Construction Contract have the meaning assigned to them in the General Conditions, except for the terms "General Requirements." The term "General Requirements" is not applicable to this Contract, and items referenced as appearing in that section will be located in the Technical Specifications or these Supplemental General Conditions. The term "Substantial Completion" is further defined as follows: Substantial Comoletion - Additional Clarification The project shall not be considered Substantially Complete until the following minimum conditions have been met: 1) All major individual items of construction must be sufficiently complete in accordance with the Contract Documents so that the individual item of construction can be utilized for the purposes for which it is intended. 2) Required tests, such as air, hydrostatic pressure, water tightness, compaction, and others, including trial operating tests, as outlined in the Technical Specifications must be successfully completed. Any items that fail any of the tests must be corrected and retested. 3) A preliminary final inspection must have been requested by the CONTRACTOR and, allowing adequate time for the presence of all necessary parties, conducted by the ENGINEER. Such prefinal inspection must show that 1 and 2 above have been accomplished. The punchlist developed at the prefinal must not contain any major deficiencies. As of the date that items 1 through 3 above have been completed, the ENGINEER shall issue the Certificate of Substantial Completion, which shall act to initiate the guarantee period and to stop the assessment of additional liquidated damages (if the agreed-upon time has expired) as of that date. The Certificate shall provide a mutually agreed upon reasonable period of time for completion of the punchlist items, and failure of the CONTRACTOR to complete the punchlist items within this period shall be cause for the OWNER to reinstate the withholding of liquidated damages in the amount and under the terms previously specified in the Contract. Add the following definitions: The word "Approved" means to give limited, or conditional, or qualified permission to use material, equipment, or methods, the conditions being in strict compliance with contract document requirements. The words "Furnish", or "Install", or "Provide" mean to supply, make available, place and/or fix into position. These words are used interchangeably. The word "Inspection" means to make general, periodic visual observations of the material and installation, but not detailed continuous, or specific analysis of the same. The ENGINEER'S City of Paris, Texas 00 73 00 Page 1 of 8 Supplemental Conditions 9/10/2020