Laserfiche WebLink
P. 2b' x 4b' bracing must be cut into last two rafters and naiied to barge rafters (4 per gable) <br />9.0 Millwork, Cabineb and Trim <br />9.1. Materials <br />A. Trirn materiels must be of select grade of white pine or equivalenL Cabinet plywood must be of A <br />grade or equivatent (paint or stain grade as per specifications). Pine or fir plywood not permitted <br />for cabinets. <br />B. Finger jointed material must not be allowed on surfaces to be varnished. <br />9.2. Cabinets: <br />A. Face fiames must be made of 3/4" A grade birch, oak or ash plywood. End panels and bottoms <br />must be'/z", plywood. Cabinet backs and tops must bc 318", roedium densiry particle board with <br />filled bull nosed edge. <br />B. Doors must be'/+" A grade birch, oak or ash plywood, ttimmed with lip mold <br />C. Drawer fronts must be same as doors. Sides, panels, and bottoms of 3g plywood. <br />D. Factory built cabinets must have plywood or solid wood fronts. Particie board is not permitted. <br />E. Cabinet hardwan must includc the following: <br />1. Drawer suspension must be self-aligning three (3) points nylon roller suspenaion. <br />2. Drawer and cabinet puils must be anrique brdss finished or wooden and properly fitted for <br />ease of use. <br />9.3. Countertop must be light colored roll front, roll back, pmformed, laminated countertop, or as per project <br />specifications. ConUactor to provide homeowner with three se]ectipn5, <br />9.4. Methods <br />A. Finish work must be finished smooth, frce from machine or tool matks, abrasions, raised grain, <br />etc., on exposed surfaces, and must be machine sanded and hand dressed to a smooth filrish. <br />B. All molded members and irim must be mitered or eoped at cornecs. <br />C. All measurements and dimensions must be verified by the contracWr at the job. <br />D. Narls must be countmunk aad Slled. <br />E. Cabinets must be set Ievol <br />F. All joints must hsve countersunk nailing and glue. <br />G. Factory built cabinets must be installed as per plans and specifications or as factory specs dictate. <br />H. Countertop must be light colored roll front, roll back, preformed, laminated countertop, or as per <br />project specifications. Contractor to provide homeowner with three selections. <br />TDHCA - HOME Invespnent Parmerships Program <br />Appendix A-04 - TMC Specifications Page 10 of 24 Revised 01/01f2004 <br />221 <br />