Laserfiche WebLink
E. Pre-hung units must have a frame made of'.4", material with a properly plowed jatnb to receive 1 <br />or 13g b' doors. A pre-huag unit must be equipped with the door panel, jamb, and all trim. <br />13.2. Methods <br />13.3. Exterior poors <br />A. Pre-hung exterior doors must be inatalled plumb and level. Door panel must not be trimmed or <br />manipulated in any fashion and must swing free and easy. <br />B. When a panel is to be inserted into an existing frame, the door opening rnust be level end made <br />capable of holding the tuw door. Recommended clearance from the door edge to the jamb in <br />3/16". The door must not be trimmed or maniputated in any fashion and must swing frce and <br />easy. <br />13.4. Interior poors <br />A. Pre-hung units must be installed plumb and level W insure proper operation. Bottom of the door <br />may be cut off to allow proper ventilation and operation. <br />B. When a panel is to be inserted into an existing frame, the door opening must be level and made <br />capable of holding the new door. Recommended clearance from the door to jamb is 3/16". The <br />panel must be cut off to allow proper ventiladon and operaNon. <br />C. Bi-folding or louvered bi-folding doors must be used where specified. They must have fow <br />panels and 6ave pulls attached to the outside two. They must be installed plumb and must fit <br />evenly and snug between buttcd panels. <br />D. Pre-hung wooden doors vented a minimum of 100 square inches, top and bottom, must be used on <br />gas water heater closet door openings. Door must bo installed plurnb and level for proper <br />operation. <br />13.5. Storm Doois <br />A. If mounting surface is rotten or in any manner deteriocated, it must be replaced. <br />B. Storm doors must be instaUed with screw fasteners and must be caulkai and well fitted. <br />13.6. Screen Doors <br />A. Wooden screen doors must be installed level and bo closely fitted to insure protection from rodent <br />and insect infiltration. If the mounting sarface is rotten or deteriorated, it must be rtplaced. <br />B. Aluminum screen doors must comply with the specificatioas for, storm doors. <br />13.7. Door Repair <br />A. Entrance doors must have 1'/:", pair of door butts, weatherstrip threshold (mede of rolled vinyl <br />with aluminum channel backing). <br />B. Any ~ or miasing parts must be replaced. <br />C. All make-shift door frames must be replaced (fill in all holes at doors to be neat and pennanent). <br />D. All doors must fit and work properly. <br />TDTiCA - F30ME Investment Partnerships Prograzr► <br />Appendix A-04 - TMC Specifications Page 15 of 24 Revised 01101/2004 <br />