Laserfiche WebLink
MR Division 6-B~ <br />2 Finish Carpentry <br />WOOD CABINETS: Furnish and install complete all cabinets, <br />casework, and shelving units as shown on plans or called <br />'•for. Construction shall be approved by the Architect. <br />Face frames shall be 3/4" solid lumber of natural birch. <br />Door and drawer faces shall be 3/4" natural birch plywood. <br />Door and drawer faces shall be over lap type. <br />The interior of the cabinets shall have back panels and <br />floor of matching plywood. Open cabinets and upper cabinets <br />shall be finished on the interior same as the exterior. <br />Shelving for cabinets shall be as follows: base cabinets <br />shall have one full depth shelf. Upper cabinets shall <br />have fixed shelves 12" on center. All shelving shall be <br />5/8" plywood with birch veneer. <br />'Cabinets shall be furnished complete with hardware including> <br />concealed spring hinges, K.V. #1300 drawer slides, and <br />"wire" pulls for drawers and doors. <br />'.Cabinets shall be factory finished. Provide on all wood <br />work a coat of stain wiped off color as selected by the <br />_ Architect, a spray "shading" coat of stain, and two coats <br />of lacquer. <br />CABINET TOPS AND WORK TOPS: <br />HIGH PRESSURE LAMINATE (H.P.L.) COUNTER TOPS shall be <br />Standard Post Form Grade Formica mounted with waterproof <br />adhesive as recommended by manufacturer and of color selected <br />by Architect. Counter tops shall be furnished and completely <br />assembled and installed by cabinet manufacturer. Counter <br />tops shall be "Fully-Formed" with dripless front rolled edge, <br />and 4!!ccoved back splash. Provide 4" high end splash at sidewalls. <br />31 <br />