04-B Asbestos Abatement Bid - Laserfiche WebLink

Home Browse Search

ERI Consulting, Inc. program, which includes all items in OSHA29 CFR 1910.134 (b) (1-11). This program shall be posted in the clean room of the worker decontamination enclosure system. 3.3.2.2 Workers shall be provided with personally issued, individually identified (marked with waterproOf designations) respirators. Respirators must be cleaned and sterilized following each period of wear. 3.3.2.3 Respirators shall be selected that meet the requirements in OSHA 29 CFR 1926.1101 (h) and provide protection inside the respirator to a level of 0.05 fibers /cc based on personal breathing zone air samples. Owner's Representative may require type "C" air supplier in pressure demand mode initially and allow downgrading based on personal sample results to provide levels at or below 0.05 f/cc or less inside the mask. The NIOSH/MSHA Type "C" air-supplied respirators in pressure demand mode with full facepieces and HEPA filtered disconnect protection or emergency air bottle shall be provided to all full-shift asbestos abatement workers. Powered air-purifying respirators equipped with HEPA filtration and full facepieces may be utilized for inspection or repair work of less than one (1) hour duration. (See Section 2.2.1.2). 3.3.2.4 Fit testing 3.3.2.4.1 Workers must perform positive and negative air pressure fit tests each time a respirator is put on, whenever the respirator design so permits. Powered air-purifying respirators shall be tested for adequate flow as specified by the manufacturer. 3.3.2.4.2 Workers shall be given a qualitative fit test in accordance with procedures detailed in 29 CFR 1926.1101. Half-face air purifying respirators may be fit tested by Qualitative protocol. Other types shall be tested by Quantitative protocol where required. 3.3.2.4.3 Documentation of adequate respirator fit must be provided to the Owner's Representative. 3.3.2.5 No one wearing a beard shall be permitted to don a respirator and enter the work area. 3.3.2.6 Additional respirators (minimum of 2 of each type) and training on their donning and use must be available at the work site for authorized visitors who may be required to enter the work area.