Laserfiche WebLink
1, Assist the OWNER in selecting colors, textures or other aesthetic features. <br />2. Compare the proposed features of the product with the specified features so <br />as to advise the OWNER that the product does, in general, conform to the <br />Contract Documents. <br />3. Compare the performance features of the proposed product with those <br />specified so as to advise the OWNER that it appears that the product will meet <br />the designed performance criteria. <br />4. Review required certifications, guarantees, warranties, and service <br />agreements for compliance with the Contract Documents. <br />C. Certify that CONTRACTOR has reviewed the Shop Drawings and made all necessary <br />corrections such that the products, when installed, will be in full compliance with the <br />Contract Documents per Section 00 73 00 — Supplemental Conditions. Shop Drawings <br />submitted without this certification will be returned without review. <br />D. Submit Shop Drawings for: <br />1. Products indicated in the submittal schedule following this Section. <br />2, When a substitution or equal product is proposed in accordance with <br />Paragraph 1.08 of this Section. <br />E. Include a complete description of the material or equipment to be furnished. <br />Information is to include: <br />1. Type, dimensions, size, arrangement, model number, and operational <br />parameters of the components. <br />2. Weights, gauges, materials of construction, external connections, anchors, <br />and supports required. <br />3. Performance characteristics, capacities, engineering data, motor curves, and <br />other information necessary to allow a complete evaluation of mechanical <br />components. <br />4. All applicable standards such as ASTM or Federal specification numbers. <br />5. Fabrication and installation drawings, setting diagrams, manufacturing <br />instructions, templates, patterns, and coordination drawings. <br />6. Wiring and piping diagrams and related controls. <br />7. Mix designs for concrete, asphalt, or other materials proportioned for the <br />Project. <br />8. Complete and accurate field measurements for products which must fit <br />existing conditions. Indicate on the submittal that the measurements represent <br />actual dimensions obtained at the site. <br />F. Provide all required statements of certification, guarantees, extended service <br />agreements, and other related documents with the Shop Drawing. The effective date <br />of these documents shall be the date of acceptance of the work by the OWNER. <br />G. Comments will be made on items called to the attention of the ENGINEER for review <br />and comment. Any marks made by the ENGINEER do not constitute a blanket review <br />of the submittal or relieve the CONTRACTOR from responsibility for errors or <br />deviations from the Contract requirements. <br />H. Submittals that are reviewed will be returned with one or more of the following <br />designations: <br />1. Approved - Submittal is found to be acceptable as submitted. <br />City of Paris, Texas 01 33 00 -• Page 5 of 11 Submittals <br />9/10/2020 <br />