05-D Animal Shelter Contract - Laserfiche WebLink

Home Browse Search

Division 9-B ' Drywall GYPSUM BOARD APPLICATION (CONTINUED): All fastening shall ~ be dimpled into the surface of the board and fasteners must pull tight. Secure board at top.and bottom edge. No vertical joints shall occur closer than 12" from door - or window jamb. Provide control joints as required, in . no case shall walls exceed 30'-0" without a control joint. Stagger joints each side of studs. INSPECTION: No wall board shall be installed until all studs, hangers, insulation, etc., is in place and approved by the Architect. GYPSUM BOARD CEILINGS: Where finish Schedule calls for gypsum board ceiling, same shall be applied to Chicago Metallic Corp. #630 suspension system with furring 16" O.C. Hanger wires shall be spaced 4'-0" o.c. maximum and shall be 8 gauge. Provide continuous backing for fasteners on the edges of each sheet including wall and ceiling intersections. GYPSUM BOARD JOINT TREATMENT AND TEXTURED FINISH: All . joints in gypsum board shall be bedded and taped and all exposed surfaces finished in a texture. Install Perf-A-Tape in accordance with direction of manufacturer. This portion of the work shall be done by skilled mechanics. - All joints must be brought to a true and uniform surface. ' The amount of joint work required will depend upon the framing and erection of gypboard. Use a steel trowel and extend mud as much as 12" from joint to provide a smooth uniform surface. The joint system shall be inspected under good light and approved before any texture or wall covering is applied. Mask windows, ducts, and surfaces not to receive texture. Surfaces to receive texture shAll have one coat applied to the joints only and brushed out well at the edges. After this coat is dry, apply one heavy coat of texture to entire surface, finishing in a light stipple. Surfaces to receive vinyl wall covering shall have finished joints and a smooth uniform surface without texture. CLEANING: Clean drywall and adjoining surfaces including the edges of casings, doors, windows, floors, etc., and repair any damage from such cause. Wall board shall be approved before application of paint.