Laserfiche WebLink
Division 9-G <br />Flooring <br />INSTALLATION (CONTINUED): <br />" layment' as manufactured by Kaiser Manufacturing, Inc. <br />or approved equal. Underlayment shall consist of one part <br />Liquid Latex and one part Dry Powder applied according <br />_ to manufacturer's specifications. <br />Clean floors free of dust, dirt, and grease before laying <br />floor. Lay in full bed of adhesive, with all joints straight <br />and tight. Tile to be laid symmetrically about center <br />of rooms with not less than one-half width of tile at walls. <br />Before adhesive is applied, floors shall receive a primer <br />as recommended by the adhesive manufacturer. Where there <br />is no metal threshold and where covering does not extend <br />into adjoining room provide 2" vinyl edging strip under <br />doors and openings. <br />Rubber base shall be neatly installed with mitered inside <br />corners. Rubber base shall be free from buckles and wrinkles <br />and must have 1008 adhesion. <br />MATERIAL FOR REPAIR: Upon completion, the Contractor shall <br />leave for future repair: 10 pieces floor tile and 6 1in. <br />feet of rubber base, <br />CLEANING: Remove surplus adhesive from floors and adjoining <br />surfaces. When building is otherwise complete, clean sur- <br />_ faces of any foreign matter, and buff. Buffing shall be <br />done with a heavy duty buffer. <br />b1 <br />